Oops again - faired thru glass to the wood at a high spot

Opps... while fairing with the long board, one of the highest spots was at one of the few footballs. This section sits right on the rear frame. I sanded through the glass and just barely hit wood. No good! Since it is a high spot, if there is a scrape anywhere near this area, it will likely scrape here. No point in delaying the repair. I had a pretty good fairing job going, but building this up, for the sake of protection, will leave a slight bump. No choice. Making it invisible would use too much epoxy and time. You can see at the left edge, barely cutting wood...