Transom Assy

Had to raise the height of the transom lockers to accomadate out board controls. It was too sharp of a bend once the cables exited the stbd locker to connect properly to the outboard. Gonna run my gunwhale siderails at the same level and tie everything together.
I also decided to forget about side drains, made a cut-out in the transom bulkhead and gave the motor well two 1_1/4" drains. Hopefully this won't swamp my boat and will allow LOTS of water to get out.
That's not air bubbles in the 12 oz. tape. Just sanded it.