Most viewed - Texas XF20 |
transom and stringers are finally aligned 13 viewsMrPaul
|
|
|
|
measured and marked for frames and stringers12 viewsMrPaul
|
|
got a bubble right on the joint. looks like I'll have to sand it down and tape it again tomorrow.12 viewsMrPaul
|
|
|
|
|
pot life with the slow hardener is not so slow11 viewsMrPaul
|
|
too much epoxy but the stringers are glued11 viewsMrPaul
|
|
hope this is good wood11 viewsMrPaul
|
|
after dragging the bottom over the stringers, I discovered the stringers weren't quite aligned. Aligning stringers under the bottom is a pain in the rear.11 viewsMrPaul
|
|
117 files on 10 page(s) |
|
|
4 | |
|
|
|
|
|