|
First step was to build a table to work on.235 viewsBill Bulloch
|
|
The small boat on the workbench was my pratice boat -- a V10 scaled down 40%.264 viewsBill Bulloch
|
|
Cutting the parts -- used 1/2 PVC to draw curves.170 viewsBill Bulloch
|
|
|
Cut one panel of the side, then used double sided tape to route the other side to match.171 viewsBill Bulloch
|
|
|
The tape was hard to get off, but Acetone did the job.174 viewsBill Bulloch
|
|
butting the sides together. I'll cut the cleats off once the glue dries.170 viewsBill Bulloch
|
|
|
The frames. Noticed that I doubled the uprights on the frames. I am going to hold them to the side temporary with screws and the dobule thickness (3/4") makes it easier. Besides, I like the looks of the thicker upright on the frames.188 viewsBill Bulloch
|
|
|
I stiched the bottome together first, then I opened it like a book and the curve was there.227 viewsBill Bulloch
|
|
|